How you can Build a Patio Mist Cooling fan
Do It Yourself Patio Misting Cooling Fan
The following instructions show you the simplest way to assemble a mist system ring on a home cooling fan to construct your own personal mister fans. This setup lets you to produce an great mist fan utilizing the water pressure from your patio water faucet. It’s terrific for cooling 1 or 2 folks on your deck. It can also be put to use to cool off your dog or other pets, or even a small chicken coop or rabbit hutch.
Things you’ll need:
- Fan – 16 in . or larger
- Mister Ring with low-pressure mister nozzles
- Low water pressure mister fan adapter kit (includes low pressure line, hose bib connector, zip ties, 1/4-inch push lock fitting for the misting ring).
- Close by hose water faucet.
- Electrical cord
- Electric Outlet with a ground fault circuit protector
The faucet adapter should already be installed on the tubing, but if not, simply put the tubing directly into the little side of the connector. It can be a snug fit, so in the event that you have trouble doing that manually, utilize a pair of pliers to help drive the tubing in.
If you purchased a outdoor mister fan with a misting ring, a push lock connector should be mounted on the ring. If you got the mist fan adapter kit separately, it will come with a fitting that you will have to mount on the mister ring. If the connector doesn’t include teflon tape wrapped around it, you’ll need to wrap the male end 2 to 3 times, after that install the fitting in the mister ring.
Push the tubing completely into the fitting, then slightly pull back to make certain the tubing is tight in the fitting.
In the demo, I use a relatively inexpensive box fan I got at Home Depot a couple of years ago. Lay the fan flat, then center the misting ring over the exhaust side of the fan, with the nozzles directing away from the fan.
Attach the mist ring onto the fan using zip ties that came with the low-pressure misting fan adapter kit. Fold the zip tie first, which will make it much easier to thread in and around the ring and the grid of the fan shield. Draw the ties tight, then snip off the ends to make things tidy. You may put the fan up-right now, making certain the misting ring is secure.
Plug the fan into a ground fault protected electric outlet. A Gfci outlet is the type with a black “Test” and a red “Reset” button. These types of electric sockets bread the circuit when there is a “ground fault,” which happens when the electrical current finds an alternative route to ground. For instance, it might try to journey through your body if you’re foolish enough to be standing in a puddle of water. Don’t be dumb – always be very careful when utilizing electrical power in the presence of water. In modern residences, electric outlets on the exterior of the dwelling are commonly on a Gfci circuit or are GFCI outlets. In many homes, the entire ground fault circuit is managed by a ground fault electric outlet in the garage. Be certain to check that it is operating correctly prior to plugging in your mister fan.
Attach the tubing with the faucet connector to the water faucet.
After plugging the fan in and turning it on, you should turn on the water to begin the misting. Now you may cool off with your mister fan!
This entry was posted on Friday, July 23rd, 2010 at 3:56 am and is filed under General. You can follow any responses to this entry through the RSS 2.0 feed. Both comments and pings are currently closed.